This will depend on how readily available the materials are. It can usually take a couple of months to complete.
it takes all a month to do it
Take a drill and dismantle it then get a circular piece of wood, cut a hole in the middle, and fasten the drill to it, mount it to a base and get a sufficient power source
In the area of industrial pipe fittings: Long radius 90 deg elbow has a take off dimension of one and one half times the nominal diameter of the pipe. Ex-4 inch pipe has an actual diameter of 4.5, for the elbow the take off dimension would be 4"*1.5=6". The short radius elbow take off dimension is the same as the nominal size, 4". To add to the point, a short radius elbow can be used typically where space is a constraint. Hence fluid flow is also restricted in this case unlike in case using of Long Elbow.
it depends what you are trying to access. you have to take out the four long bolts that are accessable from that back that run all the way up front that hold on the wet end. take off the front half of the wet end and you need to remove the propeller by threading it off by spinning it and holding the shaft from the very back with a large flat screwdriver the rest pulls apart. if you have to take it apart anymore... buy a new motor.
The answer depends on many factors:type of metal and its specific heat capacityquantity of metal in questioncurrent metal temperaturecurrent ambient temperatureDepending on these factors the answer could range from mere moments to hours or even days.
8 to 10 years
From where?
a cruise is organized with stops... one month, probably...
A large cruise ship can take between 6 and 7 hours to get from New Orleans out to the Gulf of Mexico.
Your answer depends on the size and power of the cruise ship, and its capabilities to sail in polar waters -- with icebergs.
about a day maybe
a lot of hours
8 months
20 minutes
That depends on how fast the cruise ship is traveling. Typically cruises from Baltimore take at least a day and a half to reach the Bahamas primarily due to the speed limits on the Chesapeake Bay.
It takes 13 hours.
Usually about five days.